CUL2MQTT/CHANGELOG.txt

2023-06-11:
 - add support for sensors sending 24 bit where 12 bit is the device address and 12 bit the value

2023-05-30:
 - add a status file that is touched every minute as long as something has been received

2023-05-30:
 - add no-receive-timeout after which the program will be exited (and will be restarted by systemd)
 - minor improvements

2023-05-29: 
  - fix #1 - TypeError: cannot unpack non-iterable NoneType object
        add try/except to catch this rarely occuring error
        cul2mqtt.py[1850863]: parseRXCode(inCmd, source_cul)# May 03 14:41:11 pve cul2mqtt.py[1850863]: File "/home/pi/cul2mqtt/cul2mqtt.py", line 434, in parseRXCode
        cul2mqtt.py[1850863]: receivedForDevice, receivedCmnd = decodeInterTechnoRX(rx_code_stripped)
        cul2mqtt.py[1850863]: TypeError: cannot unpack non-iterable NoneType object
	
2023-03-14:
  - fixed bug in MQTT on_message callback if add_statTopics_on is defined for device
  
2022-11-18:
  - basic support for sensors sending values
  - small changes to config structure (TX_interface_prefer moved to cul section)

2021-03-14:
  - added support for using Tasmota ESP8266 firmware as a Serial Bridge for building an MQTT-CUL rather than my own outdated, instable and never published MQTT-Serial-firmware
    tested with Tasmota v9.3.1

2020-12-09:
  - fixed bug: program terminated when UART-CUL enabled/configured but not available
  - fix bug in MQTT input when using 'add_statTopics_on'
  - added: initialize MQTT-CUL with configured culInitCmd (i.E. "X21", "X05") on MQTT connect
  - added support for certain remote controls that aren´t directly supported by a-culfw by parsing RAW data (a-culfw initialized with X05 command)
  - added repeated commands
  - added ini configuration using configparser
  - lots of improvements and fixes
  - README updated

2020-11-30:
  - integrated support for InterTechno remotes/devices with fixed code
    no need to specify RX/TX commands, just specify a device ID like IT_A1, IT_C3 etc. 
  - added logging (logs all known received commands and status messages to file by default)

2020-04-06: 
  - devices configuration using YAML file (cul2mqtt_devices.yaml)
  - calculate TX code from RX code for InterTechno compatible devices (code from FHEM project ported to Python)
    no need any more to identify and specify TX codes for these devices, just specify the RX code and the TX is generated on the fly when needed